ELEC 240 Lab
Introduction
In the last 2 labs we looked at various kinds of signals:
DC, sinusoidal, square waves, speech, etc.
But to build our optical communication system, we will have
to do more than look.
We need to be able to manipulate signals
so that we can impress the desired information onto a
"carrier" signal to transmit it
and then extract the information from the received signal.
Another term for this signal manipulation is
signal processing.
For this lab you will need to be familiar with MATLAB, so it is advised to look over some online tutorials.
The following figure shows the basic voltage divider circuit:
![\includegraphics[scale=0.650000]{voltage_div.ps}](img160.png)
for which we have the familiar relation:
$$v_\text{out} = \frac{R_2}{R_1 + R_2} v_\text{in}$$
or
$$\frac{v_\text{out}}{v_\text{in}} = \frac{R_2}{R_1 + R_2}.$$
If \(R_1\) and \(R_2\) are fixed then the output voltage
is a constant fraction of the input,
i.e. we have a fixed attenuator.
If either or both of them vary, we have a variable attenuator
(e.g. a volume control).
If \(v_\text{in}\) is constant and one or both of \(R_1\) or \(R_2\) vary with time, then \(v_\text{out}\) will be a function of time,
following the change in \(R\).
If either or both of \(R_1\) and \(R_2\) vary with frequency
(i.e. they are impedances rather than
pure resistances)
then the attenuation
(or
transfer function)
will be a function of frequency,
i.e. we have a
filter.
Finally, if one or the other of \(R_1\) or \(R_2\) is
non-linear, then the input-output relation will reflect
that nonlinearity.
If we replace resistances \(R_1\) and \(R_2\) by impedances
\(Z_1\) and \(Z_2\) and use the phasor representation
(\(V_\text{in}\) and \(V_\text{out}\)) for the input and output voltages,
then the voltage divider relation still holds.
We define the ratio of the output voltage phasor to the input
voltage phasor to be the
transfer function:
$$H(f)\equiv\frac{V_\text{out}}{V_\text{in}} = \frac{Z_2}{Z_1 + Z_2}$$
For example if we replace \(R_2\) with a capacitor, we get the following
circuit:
![\includegraphics[scale=0.650000]{low_pass_phasor.ps}](img161.png)
for which
$$H(f)=\frac{V_\text{out}}{V_\text{in}} = \frac{Z_2}{Z_1 + Z_2} = \frac{1/j2\pi fC}{(1/j2\pi fC)+R} = \frac{1}{j2\pi fRC+1}$$
Since \(H(f)\) is close to one for small values of \(f\) and goes to
zero for large \(f\) (i.e. it passes low frequencies)
we call this circuit a
low pass filter.